For use on all Model C, D and E Indoor Rowers. This cover fits the underside of the main box frame to protect the return mechanism from dust and to keep little fingers and pets' tails safe from the moving parts inside. See more info.
For use with updated Model D, Model E and Dynamic Indoor Rowers. Replacement nylon footstrap with buckle, approximately 30" long by 1" wide with a screwhole drilled approximately 9" from the buckle end. Two per machine. Sold individually. Model D/E Flexfoot Assembly Diagram
For use with Model C, D and E Indoor Rowers. This is a 3-3/8 inch diameter pulley that the shock cord (part number 1731) runs over inside the Concept2 Indoor Rower. There are four per machine. Sold individually. See more info.
For use on the front legs of Model C, D (original and updated) and E Indoor Rowers, this is a bag of eight patched fasteners. If you need to replace missing fasteners on the front leg of your indoor rower, this is what you need. Important: For use only on the front leg of Models C, D, and E Indoor Rowers; not intended for use in other areas of the machine.
For use with Model C, D and E Indoor Rowers. These are the 1¼" diameter urethane pulleys that the chain runs over inside the indoor rower. There are two per machine: one is part of the traveling pulley (part number 1756); the other is mounted on a stationary axle and has two chain idler spacers (part number 1305) to keep it properly aligned. See more info.
For use on all Model B, C, D, E and Dynamic Indoor Rowers. This is the R8 bearing located outside of the flywheel. The corresponding bearing cup (part number 1013 or 258 depending on which model you have) is sold separately. See more info.
For use with Model A, B, C, D, E and Dynamic Indoor Rowers. This is the hard plastic cap that goes on the rear and/or front metal legs of the indoor rower to protect your carpet or floor and keep the machine from sliding back and forth while you row. Two to four per machine, depending on age and indoor rower model. Sold individually. See more info.